In-Line Sequential Gearbox for front engine and rear wheel drive cars

6 speed (RV,N,1°,2°,3°,4°,5°,6°) + Drop gear ratio

Aluminum gearbox casings

‘O' - Ring sealed casings

Straight cut teeth and ground teeth

Teeth thickness = 18 mm

Integral 1° gear on the shaft,

From 2° to 6° gear slide-on type

Sliding input drop gears

Clutch shaft on customer's request included

Lubrication pump and filter included

Quick release for reverse and neutral safety cable

Output flange on customer's request included

Hydraulic slave cylinder with thrust bearing included

Mass (without bellhousing) is about 39 kg

Maximum torque admissible is about 650 Nm

Bellhousing on customer's request

Gearchange display

Inner cockpit gear lever